JWT Technology

1005 N Washington St.

Lisbon, IA  52253  USA

1-319-408-1111



STANDARD

SHEET METAL MACHINERY

Enterprise 500

WE WILL TAILOR A MACHINE TO MEET YOUR BUDGET

Enterprise 500MKIV is a high performance production plasma cutter. Our recommended machine package includes a 100% duty cycle plasma unit from HYPERTHERM.  Other plasma makers offer machines with power units rated 50% duty cycle or lower.  These smaller plasma units will not perform  continuous production cutting.  If you are willing to accept a plasma source with these limitations we can offer a lesser unit at a reduced price. 

We are a family owned company located in Lisbon Iowa with over 40 years experience in the sheet metal industry.  Our goal is to provide the most efficient, fastest and reliable HVAC cutting table with the smallest footprint possible.  Our quoted price includes all the options we recommend.  If your budget can not justify the investment cost of our machine we will do our best to work with you to meet your investment budget. 

CUT PARTIAL SHEETS WITHOUT COVERING ENTIRE TABLE


The AIR ZONE table gives you several other important advantages.  Our plasma table allows you to cut partial sheets without covering the entire table.  Our AIRZONE table design also allows you to remove finished parts while cutting.  Single exhaust table designs require you cover the entire table to maintain exhaust suction and you must wait until the entire sheet is cut before removing parts.  If you remove parts while cutting you will lose exhaust suction.

OUTSIDE AIR INTAKE CONNECTION


Our AIR ZONE table includes a connection point for outside air intake ducting.  This allows you to duct unheated outside air to the table to supply the cutting table exhaust.  It is easy to calculate the energy savings of our AIRZONE table design.  Divide the cubic feet area of your shop by the cubic feet per minute capacity of the exhaust fan you use.  The result is the number of  times per hour the heated air in your shop must replaced be while cutting with a conventional plasma table.

AIRZONE* TABLE EXHAUST =  CLEANER CUT PARTS


The Enterprise Plasma AIR ZONE* cutting table has five separate cutting zones, each with an exhaust port instead of a single hole exhaust for the center of the table as provided by other makers.  Each of our five table cutting zones include computer controlled air intake and exhaust dampers. These dampers direct the exhaust air flow only to the zone directly beneath the cutting torch.  Enterprise improved exhaust performance substantially reduces the cutting smoke residue on the bottom of the part when compared to other plasma table designs.  The result is cleaner cut parts. 

                                                                                   

                                                                                   *Patents applied for

FAST AND ACCURATE DIGITAL SERVO DRIVE


Our SERVO drive controller is digital for the fastest and most precise speed control available.  Motor speed reduction is done thru zero maintenance precision gear boxes.  The drive control is conversational and allows our engineers to connect and diagnose the machine via the Enterprise touch screen computer control.  This remote diagnostic capability can reduce the need for expensive service engineer travel to make repairs or adjustments. 

DUAL SIDE DRIVEN ALUMINUM BRIDGE ELIMINATES WHIP 


Enterprise 500 HVAC plasma machines have significant advantages over competitor’s plasma designs.  Our cutting bridge / gantry is made of lightweight aluminum.  This lighter weight aluminum construction allows faster acceleration and deceleration in the corners and higher operating speeds.  The cutting bridge is SERVO Motor driven on both ends to eliminate bridge whip.  Whip is evident with the heavier steel bridges / single side driven machines when they change direction at similar speeds. 

THE PERFECT REPLACMENT PLASMA MACHINE 


Designed and built in Lisbon, Iowa, the Enterprise 500 plasma cutter is designed to be the perfect replacement plasma cutting machine as well as new addition to your plasma cutting capability.  Designed to run on your existing software, the machine is compatible with all major software packages. Using your existing software can lower your overall investment costs.


Plasma Machines

New machines & control upgrades

Enterprise 500MKIV

​A HIGH PERFORMANCE PRODUCTION PLASMA CUTTER

Optional

Plasma Coil Feed